Kenmore Elite 95223 Owner's Manual download pdf (Page 25)

TROUBLESHOOTING

CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY.

Problem Possible Causes Solutions

Nothing will operate Power supply cord is unplugged Plug into a grounded outlet.

ENERGY SAVE is active

andthedisplay is blank

Press any keypad on the control to display the time of day. See

the“Electronic Oven Controls” section for more information.

Household fuse is blown or a

circuit breaker is tripped

Replace the fuse or reset the circuit breaker. If the problem

continues, call an electrician.

The control displays an F9 or

F9E0 error code

The electrical outlet in the home may be miswired. Contact a

qualied electrician to verify the electrical supply.

Cooktop will not operate The control knob is set

incorrectly

Push in knob before turning to a setting.

Excessive heat around

cookware on cooktop

Cookware that is not the

propersize

Use cookware about the same size as the surface cooking area,

element, or surface burner. Cookware should not extend more than

1/2" (1.3 cm) outside the cooking area.

Cooktop cooking results

not what expected

Control knob set to incorrect

heat level

See the “Cooktop Use” section.

Range is not level Level the range. See the Installation Instructions.

Cooktop element

cycleson and off

onHisetting

Element cycling due to a

temperature limiter

This is normal operation. The element may cycle on and o to

keep the cooktop from overheating.

Oven will not operate Delay Start is set See the “Electronic Oven Controls” section.

Oven control lockout is on Press and hold START for 3 seconds to unlock.

Control is in Demo mode Demo mode will deactivate all oven elements. See “Demo Mode”

in the “Electronic Oven Controls” section.

Electronic oven control set

incorrectly

See the “Electronic Oven Controls” section.

Oven temperature

toohigh or too low

Oven temperature needs

adjustment

See “Oven Temperature Control” in the “Electronic Oven Controls”

section.

Oven indicator

lightsflash

Power to range is turned on

orrestored

See “Control Display” in the “Electronic Oven Controls” section.

Ifthe indicator light(s) keep ashing, call for service. See the

backcover for more information.

Display shows messages Power failure (display shows

ashing time)

Clear the display. On some models, reset the clock, if needed.

Seethe “Clock” keypad feature in the “Feature Guide” section.

Error code (display shows letter

followed by number)

Depending on your model, press STOP to clear the display.

See“Control Display” in the “Electronic Oven Controls”

section.Ifit reappears, call for service. See the back cover

formore information.

Clean cycle did not work

on all spills

Several cooking cycles between

Clean cycles or spills on oven

walls and doors

Run additional Cleancycles. Kitchen and appliance cleaner

orcooktop cleaner can be used for stubborn soils.

Mineral deposits are left

on the oven bottom after

the Clean cycle

Tap water was used in the

Clean cycle

Use distilled or ltered water in the Clean cycle.

To remove deposits, use a cloth soaked with vinegar. Then use a

cloth dampened with water to thoroughlyremove any vinegar

residue.

Range is not level Mineral deposits will collect on dry areas of the oven bottom

during the Clean cycle.Level the range. See the Installation

Instructions.

To remove deposits, use a cloth soaked with vinegar. Then use a

cloth dampened with water to thoroughlyremove any vinegar

residue.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 87 88

Comments to this Manuals

No comments

Kenmore Elite 95223 Owner's Manual Page 25

Comments to this Manuals

Related products and manuals for Cookers Kenmore Elite 95223