Kenmore Elite 31553 Owner's Manual download pdf (Page 32)

32

BEFORE CALLING FOR SERVICE (continued)

Problem Possible Cause Solutions

Water in the washer drains

slowly or not at all, or the

display shows:

Drain hose is kinked, pinched, or

clogged.

Drain discharge is more than 96 inches

above bottom of washer.

Make sure the drain hose is free of

clogs, kinks, etc., and is not pinched behind

or under the washer.

Adjust or repair drain. Maximum drain

height is 96 inches (8 ft.)

The display shows:

The washer has detected an out of

balance load.

If the washer detects a load that is too

far out of balance to spin, it will dis-

play this code while it is attempting to

rebalance the load. The washer will

add water and try to redistribute the

load automatically. This display is for

your information only, and no action is

required.

The display shows:

If the uE rebalance (see above) is not

successful, this error will be displayed.

The load is too small.

Heavy articles are mixed with lighter

items.

The load is out of balance.

The automatic attempt to rebalance the load

was not successful. The cycle has been paused

to allow the load to be manually adjusted.

Small loads may need additional items to be

added to allow the washer to balance the

loads.

The load may have heavy items loaded with

lighter items. Always try to wash articles of

somewhat similar weight to allow the washer

to evenly distribute the weight of the load for

spinning.

Manually redistribute the load if articles have

become tangled preventing the automatic

distribution from working properly.

The display shows:

Control error. Unplug the washer and wait 60 seconds.

Reconnect power and try again. If the error

reappears, call for service.

The display shows:

Water level is too high due to a faulty

water valve.

Close the water faucets, unplug the wash-

er, and call for service.

The display shows:

The water level sensor is not working

correctly.

Close the water faucets, unplug the wash-

er, and call for service.

The display shows:

A motor error has occurred. Allow the washer to stand for 30 minutes

and then restart the cycle. If the LE error

code persists, call for service.

7KHGLVSOD\VKRZV

Clutch error. Mechanical failure.

Unplug the washer and call for service.

7KHGLVSOD\VKRZV

Foreign objects, such as coins, pins, clips,

etc., caught between the wash plate

and the inner basket.

Turn off the washer and then press the

Power button. Press the spin speed button

without selecting a cycle to drain and

spin the load.

When the spin is complete, remove the

FORWKHVDQGWKHQÀQGDQGUHPRYHDQ\

objects caught in the wash plate.

Always check pockets, etc., before wash-

ing to prevent error codes or damage to

the washer or clothing.

TROUBLESHOOTING GUIDE

5.4 G<MZZIQVLL  ࿼ፎ"

1 2 ... 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments