Kenmore Elite 21814 Owner's Manual download pdf (Page 9)

CANISTER

1. Open the canister hood.

2. Check to see that the dust bag is

properly installed. See BAG CHANGING

(page 19) for instructions.

3. Check to see that the motor safety 

is properly installed. See MOTOR SAFETY

FILTER CHANGING (page 20) for

instructions.

HOOD AND TOOL STORAGE

COVER

It is normal for the canister hood and tool

storage cover to come  when opened

further than needed.

HOSE

To install: Line up

the hose latch tab

with the notch in

the canister hood,

and insert hose

into canister until

it snaps into place.

IMPORTANT:

The vacuum cleaner will not operate until

hose is fully connected.

To remove: Do not open hood before removing

hose. With hood closed, press the hose latch

tab in to release and remove hose.

TO REINSTALL TOOL STORAGE COVER:

1. Press tool storage cover bracket down.

2. Align front edges of tool storage cover

on canister hood.

3. Press rear of tool storage cover down

until it snaps into place.

Hose Latch

Tab

Notch

Tool Storage

Cover Bracket

TO REINSTALL HOOD:

1. Lift hood bracket

up as shown.

2. Align tabs located on the hood with slots

located on the hood bracket. Press hood

into hood bracket until it snaps in place.

- 9 -

3. Press hood slightly

towards the rear of

the canister.

4. Lower hood to

close. Press until

hood latch snaps

into place.

Hood

Bracket

Slots

Tab

Hood

Bracket

Hood

Tab

Hood

Latch

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Comments to this Manuals

No comments